[sword-devel] mod2zmod

[Johan Marais]

I figured it out, one should have a working module (unencrypted and
uncompressed) with the relevant .conf file.

Then run mod2zmod and then rename or remove the unencrypted and uncompressed
module and that .conf file.

Regards,

Johan

-----Original Message-----
From: Johan Marais [mailto:johan.marais at messianic.co.za] 
Sent: 08 December, 2014 9:54 AM
To: 'SWORD Developers' Collaboration Forum'
Subject: Re: [sword-devel] mod2zmod

The .conf file looks as follows:

[TS2009]
BlockType=BOOK
Category=Biblical Texts
CipherKey=abc
CompressType=ZIP
DataPath=./modules/texts/ztext/ts2009/
DistributionLicense=Copyrighted; Permission granted to distribute
non-commercially in SWORD format
Encoding=UTF-8
GlobalOptionFilter=OSISFootnotes
GlobalOptionFilter=OSISScripref
LCSH=Bible.English
Lang=en	
MinimumVersion=1.5.3
ModDrv=zText
SourceType=OSIS
SwordVersionDate=2002-02-22
Versification=KJV
Version=1.0
(I have taken out the copyright address, copyright notice, etc.)

The command is as follows:
mod2zmod.exe TS2009 .\modules\texts\ztext\ts2009\ 4 2 abc

Please assist.

Johan

-----Original Message-----
From: JohanMarais [mailto:johan.marais at messianic.co.za]
Sent: 07 December, 2014 11:03 AM
To: sword-devel at crosswire.org
Subject: Re: [sword-devel] mod2zmod

I experience problems with 'mod2zmod' for a bible module.

I am using the latest version from Xiphos.

The source .txt plus the 4 files created by 'imp2vs' are in the same folder
as 'mod2zmod'.

I am using the correct syntax, but it says "No entry in module". Six files
are created in the output folder though. When I open the module in Xiphos or
The SWORD project, it is empty. My questions are the following:

1) What needed to be in place / to be done before running 'mod2zmod', e.g.
do I need to run 'imp2vs' first?

2) What is the source of 'mod2zmod' as it only refers to the [ModuleName],
is it the 4 files created by 'imp2vs' or the source text file?

When I right click in the module in Xiphos, it does show the "About" details
as per the .conf file.

Thank you, any help is appreciated.



--
View this message in context:
http://sword-dev.350566.n4.nabble.com/mod2zmod-tp4381520p4654280.html
Sent from the SWORD Dev mailing list archive at Nabble.com.

_______________________________________________
sword-devel mailing list: sword-devel at crosswire.org
http://www.crosswire.org/mailman/listinfo/sword-devel
Instructions to unsubscribe/change your settings at above page


_______________________________________________
sword-devel mailing list: sword-devel at crosswire.org
http://www.crosswire.org/mailman/listinfo/sword-devel
Instructions to unsubscribe/change your settings at above page