[sword-devel] Making module and conf file

[Matthew Talbert]

Perhaps I missed a step, but previously he had specifically said he
was using the Xiphos "local source" option, which is using SWORD to do
the installation.

On Fri, Oct 1, 2010 at 3:41 PM, Troy A. Griffitts <scribe at crosswire.org> wrote:
>
> Well, in your case it is neither.  You manually installed the module.
> The auto installer in SWORD to which Matthew is referring will install
> from one local repository to another or from a remote repository to
> another, but you didn't use the installer to do any of this.  You copied
> the files in place manually-- which is necessary for module create.  Now
> you can install FROM that location on another computer or if you point
> an FTP server to that location you call allow other to install FROM that
> location to their computer over the internet.
>
> Troy
>
>
>
> On 10/01/2010 08:28 PM, Matthew Talbert wrote:
> >> Is it Sword code or Xiphos code that does the actual installation?
> >
> > Sword.
> >
> > Matthew
> >
> > _______________________________________________
> > sword-devel mailing list: sword-devel at crosswire.org
> > http://www.crosswire.org/mailman/listinfo/sword-devel
> > Instructions to unsubscribe/change your settings at above page
>
>
> _______________________________________________
> sword-devel mailing list: sword-devel at crosswire.org
> http://www.crosswire.org/mailman/listinfo/sword-devel
> Instructions to unsubscribe/change your settings at above page