[sword-devel] 1.8, French versifications, modules

[Peter von Kaehne]

I think so, yes. 

Sent from my phone. Apologies for brevity and typos.On 12 Mar 2016 2:27 am, DM Smith <dmsmith at crosswire.org> wrote:
>
> Found them attached in an earlier email. There are 3 canon files, segond, darbyfr and calvin. Are we doing all 3? 
>
> I'm working on adding them to JSword. 
>
> In Him, 
> DM 
>
> > On Mar 11, 2016, at 8:22 PM, DM Smith <dmsmith at crosswire.org> wrote: 
> > 
> > Where can I find the canon_*.h files? 
> > 
> > In Him, 
> >    DM 
> > 
> >> On Mar 11, 2016, at 3:00 AM, Peter von Kaehne <refdoc at gmx.net> wrote: 
> >> 
> >> This is just to say as no one has voiced any objections to domcox' s French versifications i will now actively use these if suitable modules are submitted. 
> >> 
> >> These will be marked as requiring version 1.8 which quite clearly is not yet released, but i think is stable enough dossing about in svn. 
> >> 
> >> So while current frontends would be unable to make use of such modules, at least we would have asap compatible modules out there, maybe increasing the pressure to release. 
> >> 
> >> I have no specific texts in mind but simply notify that any new texts will be considered this way. 
> >> 
> >> Peter 
> >> 
> >> Peter 
> >> 
> >> Sent from my phone. Apologies for brevity and typos. 
> >> _______________________________________________ 
> >> sword-devel mailing list: sword-devel at crosswire.org 
> >> http://www.crosswire.org/mailman/listinfo/sword-devel 
> >> Instructions to unsubscribe/change your settings at above page 
> > 
> > 
> > _______________________________________________ 
> > sword-devel mailing list: sword-devel at crosswire.org 
> > http://www.crosswire.org/mailman/listinfo/sword-devel 
> > Instructions to unsubscribe/change your settings at above page 
>
> _______________________________________________ 
> sword-devel mailing list: sword-devel at crosswire.org 
> http://www.crosswire.org/mailman/listinfo/sword-devel 
> Instructions to unsubscribe/change your settings at above page