[sword-devel] Katana / Maemo / N900

[Troy A. Griffitts]

Teus,

osis2mod is conservative with file permissions.  Be sure the files have
proper permissions before you deploy.

I only mention this because I often forget to grant read access to files
before deploying a module for testing and the result is only
chapter/verse numbers.

Troy



On 06/12/2010 10:33 AM, Teus Benschop wrote:
> On Thu, 2010-06-10 at 12:14 -0500, Nathan Anderson wrote:
>   
>> Then a
>> group of us decided we wanted to write a QT based version and so Katana was
>> started.  It has most of the features in Rapier; but it is a lot faster and
>> more finger friendly.  ;-)
>>
>>     
> I tried it out, and indeed, Katana is more finger friendly than Rapier,
> and Katana seems to better follow guidelines for the gui on Maemo. When
> opening the KJV, for example, Katana properly shows the text. It nicely
> fills the whole screen. WLC is the same. Aleppo too. But when opening
> the Ndebele Bible, a Bible produced by Bibledit from USFM files, it only
> displays the chapter numbers and the verse numbers. Producing this Bible
> was done through osis2mod. It displays fine in Xiphos. Are there any
> hints about how to produce a Sword module from USFM files that display
> properly in Katana? Perhaps there are certain settings in the .conf file
> that need to be set to specific values? Any help is appreciated! Teus
> Benschop
>
>
>
> _______________________________________________
> sword-devel mailing list: sword-devel at crosswire.org
> http://www.crosswire.org/mailman/listinfo/sword-devel
> Instructions to unsubscribe/change your settings at above page
>